![background image](http://html.mh-extra.com/html/icom/ic-703/ic-703_instruction-manual_612184077.webp)
62
8
SCAN OPERATION
q
Select VFO mode.
w
Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
e
Set [SQL] open or closed.
• See page a left for squelch condition.
r
Select
S2
.
• Push [DISPLAY] once or twice to select
S
.
• Push [MENU] one or more times to select
S2
.
t
Push [
(F-1)
SCN
] to start the scan.
• Decimal point blinks while scanning.
y
When the scan detects a signal, the scan turns
OFF, pauses or ignores it depending on the re-
sume setting and the squelch condition.
• During scan [TS] can be used only when resume is ON.
u
To cancel the scan push [
(F-1)
SCN
].
NOTE:
If the same frequencies are programmed
into the scan edge memory channels 1A and 1B,
programmed scan does not start.
CH
VFO A
P
O
S1
5
5
3
7
9
20
40
10
60dB
USB
S2 SCN PRI V/M
Select
VFO mode
F-1
then push [
(F-1)
SCN
]
[DISPLAY]
[F-1]
[MANU]
[SQL]
■
Programmed scan operation
q
Select memory mode.
w
Close the squelch with [SQL].
e
Select
S2
.
• Push [DISPLAY] once or twice to select
S
.
• Push [MENU] one or more times to select
S2
.
r
Push [
(F-1)
SCN
] to start the scan.
• Decimal point blinks while scanning.
t
When the scan detects a signal, the scan stops or
pauses depending on the resume setting.
y
To cancel the scan push [
(F-1)
SCN
].
NOTE:
Two or more memory channels must be
programmed for memory scan to start.
S2 SCN SEL V/M
Select
memory mode
F-1
then push [
(F-1)
SCN
]
CH
MEMO
P
O
S1
5
5
3
7
9
20
40
10
60dB
USB
[DISPLAY]
[F-1]
[MANU]
[SQL]
■
Memory scan operation
8