![background image](http://html.mh-extra.com/html/icom/ic-703/ic-703_instruction-manual_612184061.webp)
5
46
FUNCTION FOR RECEIVE
■
Simple band scope
This function allows you to visually “sweep” an area
surrounding the set frequency for other signals. De-
tected signals are indicated graphically in the dot ma-
trix section of the display.
NOTE:
Use the attenuator or turn OFF the preamp
when using the band scope on a band containing a lot
of noise.
q
Set a mode and frequency.
w
Select
G1
.
• Push [DISPLAY] once or twice to select
G
.
• Push [MENU] one or more times to select
G1
.
e
Push [F-1] one or more times to select the desired
steps.
• Each dot corresponds to a step for the indicated fre-
quency.
• 0.5k, 1k, 2k, 5k, 10k, 20k and 0.1M (100 kHz) can be
set for the scope step.
r
Push [F-3] to start the sweep.
• “
___
” (below
SWP
) flashes while sweeping.
• The receive audio is muted while sweeping.
t
Rotate the main dial if you want to monitor the dis-
played signals.
• The sweep marker indicates the location of the dis-
played frequency in the sweep readout.
• If the displayed frequency is outside of the sweep read-
out (determined by the sweep width), the sweep marker
flashes.
y
Push [F-2] to return the frequency to the start of a
sweep.
• The sweep marker moves back to the center position.
1k
SWP
2k
SWP
2k
SWP
2k
SWP
___
2k
SWP
Select sweep width
([F-1])
Start sweep
([F-3])
Sweep is finished
([F-3] again)
Move sweep marker
(main dial)
2k
SWP
Returns to previous
frequency ([F-2])
sweep marker
Main dial
[DISPLAY]
[MENU]
[F-2]
[F-3]
[F-1]
■
Preamp and attenuator
The
preamp
amplifies received signals in the front
end circuit to improve the S/N ratio and sensitivity.
Turn this function ON when receiving weak signals.
The
attenuator
prevents desired signals from distort-
ing when very strong signals are near the desired fre-
quency or when very strong electric fields, such as
from broadcasting stations, are near your location.
Push [P.AMP/ATT] momentarily to turn the preamp ON
and OFF; push for 1 sec. to turn the attenuator ON.
• Lights green when the preamp is ON; lights red when
the 20 dB attenuator is ON.
• Only one of these functions can be activated at a time.
momentarily
momentarily
1 sec.
P.AMP/ATT
P.AMP/ATT
[P.AMP/ATT]
P.AMP/ATT
Lights green while the preamp is activated;
lights red while the attenuator is activated.
4
5