Icom F3161 Series, Programming Manual

Page: 25 / 27

23
Field Description Suggested Setting
Log If enabled, the RX radio keeps a record of calls.
These can be reviewed by selecting the Call Log
feature from the display. The receive radio can log up
to 10 calls. This feature works for Individual Voice
calls or Call Alert calls only. Turning off power to the
radio clears the log. The
Log for Individual Call field
in the Individual Setting window must also be set for
Enable .
User Preference
Log Action Type
This sets how your radio responds to calls that are
logged into your radio. Only VOICE calls and CALL
ALERT calls are logged. If set to
Logged , the radio
will respond to the call with the same type of call
when you press PTT (e.g. an incoming VOICE call
that is logged, will enable you to send a VOICE call in
return). If set to
Voice , the radio will always respond
with a voice call, regardless of whether the logged call
was a Voice or Call Alert call. If set to
Call Alert , the
radio will always respond with a Call Alert call,
regardless of whether the logged call was a Voice or
Call Alert call.
User Preference
Ack TX Delay(Sec) When your radio receives a Call Alert or Radio Check
signal, this sets the length of time that your radio
waits before sending an acknowledge signal back to
the transmitting radio. 0.100
Ack RX Wait(Sec)
When your radio transmits a Call Alert or Radio
Check signal, your radio waits for an acknowledge
signal from the receiving radio. This sets that waiting
time period. If there is no acknowledgement, the radio
will retry the transmission for the number of times set
in the
Attempt No. field.
2.600
Attempt No.
The number of times your radio will transmit a Call
Alert or Radio Check signal if it doesn’t receive an
acknowledgment from the target radio. User Preference
Ringer Repeat(Sec)
Sets the time interval between rings when using
repeat rings (Pi/R, PiPi/R or PiRo/R). Only active
when
Ringer ( Call Alert window) or Ringer on
Receive ( Digital Option window) are enabled.
User Preference
Reset Timer(Sec) This sets how long the radio will stay in INDIVIDUAL
mode or TALK GROUP mode before returning to the
opening channel display. 5 Seconds
Data Decode
Comparison When this is set to ON , the radio must decode the
proper RAN code before it can receive the following
signals: Status, Status Poll, SDM, Radio Check, Stun,
Kill Revive, or Remote Monitor.
User Preference
Expert Window
Note: Settings in the Synchronization field are for digital operation only. Use the default settings in these fields.
Field Description Suggested Setting
TX All Call Allows you to transmit an all call if set to Enable .
You will also need to set a Talk Group ID of 65535.
User Preference
RX All Call Allows you to receive an all call if set to Enable .
User Preference