icetro ISI-300TA, User Manual

Page: 9 / 40

9
Do not ground to the
gas pipe or water main.
There is danger of accident.
Caution
※ The following must be checked when connecting the water supply!
1. The water pressure must be in the range of 1~3kgf/㎠.
▶
Too much pressure will cause leak from the connected part.
2. If the product is installed where the temperature drops below 10℃, be sure to prepare a freeze protection
measure for the product.
▶
Otherwise, leak or product malfunction may occur.
3. The water supply must have a valve so that it can be closed in case of malfunction of the tap on the top
of the product.
Water
Valve
●
The water supply valve may have different shapes depending
on the installation condition.
●
Follow this process!
1. Insert the o-ring into the nut of the wrinkled pipe
and tighten the nut on the water supply connecto
on the lower back of the product with a tool.
2. Make sure that “A” is not damaged
in the process.
●
Connecting the water supply
●
Connecting power
1. Be sure to connect to a single-phase power outlet with 230V and 50Hz; connect
only one product per outlet.
2. Connect the earth leak breaker (higher than 20A) to the distribution box.
3. Ground the product for safety.
4. The distance between the right side and the back of the product must be longer than 20cm,
and that between the right side and the wall must be longer than 20cm.
5. Install the rubber feet correctly to prevent slippage.
Deeper than
30cm
Copper bar
or pipe electrode
Caution
If there is no grounding equipment at the installation area, be sure to ground
the product.
- Bury a copper bar or a pipe electrode deeper than 30cm from the surface.
- Lack of proper grounding may cause electric shock due to leak.
A
For Your
Information
How to Install
20cm
20cm
20cm
●
To guarantee the optimal operation of the product, please consult
our technician on how to install the product.
(Contact our authorized technician in case of moving the product
after the initial installation.)
●
Avoid uneven surface or place with direct sunlight, too much dust,
or spattering water.
●
If the product is to be used for an extended period of time,
reset the current time.