14
W
e T
hink of Cus
tomer S
at
is
fac
tion
9. Final Installation Inspection
and Initial Operation
1) Check that the ice maker power connection, dispenser power, drain, etc. are properly
connected. Connect the ice maker and the dispenser with screws as shown in the figure
to make sure that the ice maker is installed safely so that the ice maker does not fall over.
2) Start the ice maker according to the procedure for starting the ice maker.
3) Double-check that the ice maker/dispenser assembly is level from front to back and
from left to right.
4) Connect the dispenser power and press the button to confirm operation.
- The accessory mount bracket between ice maker head and dispenser is not compatible with the
other manufacturer’s ice makers. In the event mounting other brand’s ice maker heads, consult with
local distributor or ICETRO.
- Attach the slim insulation sponge tape to seal the gap at front between ice maker head and dispenser
after mounting it up. It is to prevent dust and foreign material from falling into ice storage bin inside.
5) Put the ice chute into the ice spout.
6) When you press the ‘PUSH’ button, the wheel in the storage bin rotates and
ice comes out of the ice chute.
7) Power is supplied to the gearmotor, and when the PUSH button is pressed, ice continues
to be dispensed.
8) If the PUSH button is not pressed, there is an automatic agitating cycle for 2 seconds
every 4 hours. During the agitating cycle, ice is not discharged because the PUSH button is
not pressed.
9) Make sure to fully explain the manual to the consumer.
Connection
Screw
insulation
sponge
Summary of Contents for ID-H150-22
Page 9: ...9 4 Product Size and Description POWER SUPPLY...
Page 21: ...21 MEMO...
Page 22: ...22 We Think of Customer Satisfaction MEMO...
Page 23: ...23 MEMO...
