IceTech CD 50, Service Manual

Page: 28 / 37

Granular Ice Technical Service Manual
28 COD: IQ02_404MTIN.DOC
7.2. Speed Reducer (Gearbox)
Materials needed:
▪
Extractor
▪
M8 Screws
▪
No.12-13 monkey wrench (2)
▪
No.8-9 monkey wrench
▪
6 mm Allen key
▪
M8 nuts (2)
Procedure:
1) Remove top screw on gearbox.
2) Remove the four screws that hold flange.
3) Remover gearbox using extractor
Assembly:
1) Lubricate motor axle with grease.
2) Place gearbox face up.
3) Screw in (*) screw, place washer and lower gearbox by tightening nut.
WARNING: Do not hammer.
1) Face up clamps socket.
2) Remove (*) screw.
Place washer and tighten until spindle is flush with gearbox axle.
7.3. Upper flange
Materials needed:
▪
Extractor
▪
PHILLIPS N°2 Screwdriver
▪
M8 Screws (110 mm)
▪
No.12-13 monkey wrench (2)
▪
No.8-9 monkey wrench
▪
4, 5 and 6 mm Allen key
▪
M8 nuts (2)