IceTech CD 50, Service Manual

Page: 27 / 37

Granular Ice Technical Service Manual
27 COD: IQ02_404MTIN.DOC
7. INSPECTION AND REPLACEMENT PROCEDURES
7.1. Lower bearing
Materials needed:
- PHILLIPS N°2 Screwdriver
- M8 Screws (*)
- 5 mm Allen key
- Nylon head hammer
- No. 12-13 wrench
Procedure:
1) Disconnect unit.
2) Close faucet.
3) Remove square black plastic lower lid on machine base.
4) Remove drain plug on lower bearing.
5) Remove side screw that holds bearing with a 5 mm Allen key.
6) Introduce M8 50 mm screw in drain plug hole. Bearing will come out as you tighten
screw.
7) Check for wear inside bearing and replace if more than 0.25 mm.
8) Replace o-rings, add silicone and grease, clean evaporator and reassemble.
IMPORTANT!
Side hole must be aligned with the one in evaporator, otherwise you will not be able to
insert Allen screw in place.
1) Open water faucet and check for leaks.
2) Assemble unit and connect to power source.
3) IMPORTANT: DISCARD ICE PRODUCED DURING FIRST 15 MINUTES.