Ice VAC WD 20, Use And Maintenance Manual

Page: 23 / 32

23
CONTROLLING AND CLEANING THE VACUUM ACCESSORIES UNIT
Cleaning the entire vacuum unit properly ensures a longer lifespan
for the vacuum motor. To carry out the cleaning of the vacuum
accessories unit, proceed as follows:
1. Do what is required to make sure the machine is in a safe
condition (see MACHINE SAFETY ’”).
2. Take the appliance to its designated maintenance area.
ATTENTION
: The place this operation is carried out should
comply with current environmental protection regulations.
ATTENTION : You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
3. Remove the accessory from the extension, clean it under running
water.
ATTENTION : When it is completely dry insert it into the
accessories support at the rear of the collection tank (valid for
P30 and P60 versions), or else insert it into the storage pocket
at the rear of the collection tank (valid for P80 and P100
versions).
4. Remove the female part of the extension from the male part,
clean it under running water.
ATTENTION : When it is completely dry insert it into the
accessories support at the rear of the collection tank (valid for
P30 and P60 versions), or else insert it into the storage pocket
at the rear of the collection tank (valid for P80 and P100
versions).
5. Remove the vacuum hose (1) ( Fig.2 ) from the vacuum nozzle (2)
on the collection tank; before pulling the vacuum hose press the
button (3) for unlocking the catch (
Fig.1
).
FRONT SQUEEGEE OPTIONAL CONTROL AND CLEANING KIT (VAC WD 60 VERSIONS)
Proper cleaning of the whole front squeegee optional kit ensures
better drying of the floor, as well as a longer vacuum motor life. To
carry out the cleaning of the squeegee unit, proceed as follows:
1. Take the device to the dedicated maintenance area.
ATTENTION : The place this operation is carried out should
comply with current environmental protection regulations.
2. Take all necessary steps to ensure that the device is in a safe
condition (see MACHINE SAFETY ’”).
ATTENTION : these operations must be carried out using
protective gloves to avoid any possible contact with the edges
or tips of metal objects.
3. Remove the vacuum hose (1) from the vacuum nozzle (2) on the
squeegee body ( Fig.1 ).
4. Fully loosen the knobs (3) in the squeegee body pre-assembly
( Fig.2 ).
5. Remove the squeegee body from the slits in the squeegee
connector ( Fig.3 ).
6. First with a jet of water and then with a damp cloth, thoroughly
clean the vacuum chamber (4) of the squeegee unit (
Fig.4
).
7. First with a jet of water and then with a damp cloth, thoroughly
clean the front rubber blade (5) of the squeegee unit ( Fig.5 ).
8. First with a jet of water and then with a damp cloth, thoroughly
clean the rear rubber blade (6) of the squeegee unit (
Fig.6
).
9. Remove the vacuum hose (1) ( Fig.8 ) from the vacuum nozzle (7)
on the collection tank; before pulling the vacuum hose, press the
button (8) for unlocking the catch ( Fig.7 ).
10. Repeat the operations in reverse order to reassemble all the
parts.
3
8
2 4
2
7
1
1
1
3
6 5
1
7
1
5
3 4
2
8
2
6