Ice SCRUB 50, Use And Maintenance Manual

Page: 41 / 60

41
WORK
ECO-MODE (traction version)
This appliance has an eco-mode function, which reduces the energy
absorption.
To activate or deactivate the eco-mode function just press the button
(1) on the instrument panel ( Fig.1 ).
When the eco-mode is active, the symbols for the working programs
will change, only the contours will remain visible, like the example in
Fig.2 where scrubbing in eco-mode symbol is shown.
OVERFLOW DEVICE (50D version)
The appliance is equipped with a mechanical device (float) under the
recovery tank cap that, when the recovery tank is full, shuts off the
air to the vacuum motor intake to protect it; the sound of the vacuum
motor will then be deeper. If this is the case, proceed as follows:
1. Deactivate the supply of detergent solution by pressing the
solenoid valve command switch (1) on the control panel (
Fig.1
).
2. Deactivate the brush head gearmotor by pressing the brush head
gearmotor command switch (2) on the control panel ( Fig.2 ).
3. Raise the brush head unit off the floor by pressing the pedal (3)
on the back of the appliance ( Fig.3 ).
4. Deactivate the vacuum motor by pressing the vacuum motor
command switch (4) on the control panel ( Fig.4 ).
5. Raise the squeegee unit off the floor by means of the lever (5) on
the back of the appliance ( Fig.5 ).
6. Switch off the appliance by pressing the main switch (6) on the
back of it ( Fig.6 ).
ATTENTION: the main switch (6) is in the idle position when
the LED inside it is OFF and the activation symbol is not
visible.
7. Take the appliance to the location intended for the
discharge of dirty water and empty the recovery tank (see
paragraph“ RECOVERY TANK CONTROL AND MAINTENANCE ”
and “ CONTROL AND MAINTENANCE OF THE RECOVERY
TANK FILTER AND FLOAT SYSTEM ”).
OVERFLOW DEVICE (traction version)
The appliance is equipped with a mechanical device (float) under the
recovery tank cap that, when the recovery tank is full, shuts off the
air to the vacuum motor intake to protect it; the sound of the vacuum
motor will then be deeper.
If this is the case, proceed as follows:
1. Raise the brush head unit off the floor by pressing the pedal (1)
on the back of the appliance ( Fig.1 ).
2. Raise the squeegee unit off the floor by means of the lever (2) on
the back of the appliance ( Fig.2 ).
3. Take the appliance to the location intended for the
discharge of dirty water and empty the recovery tank (see
paragraph“ RECOVERY TANK CONTROL AND MAINTENANCE ”
and “ CONTROL AND MAINTENANCE OF THE RECOVERY
TANK FILTER AND FLOAT SYSTEM ”).
1
1
2
3
2
4 1
5
3 2 4 1
5
6
6
OFF
1 2
1 2