Ice i28BT, Operator'S & Parts Manual

Page: 9 / 38

9 ICE i28BT / i32BT
OPERATOR MANUAL
BatteRy cHaRGInG
WaRnInG: fire or explosion Hazard.
Batteries emit Hydrogen Gas. Keep Sparks and
open flame away. Keep Battery compartment
propped open When charging.
NOTE:
Use only apprved chargers with the
following specifications:
• automatic shut off circuit
• deep cycle charging
• output current of 20-30 amps
• output voltage of 24 volts
on-BoaRd BatteRy cHaRGeR
As standard configuration, the machine is equiped
with the On-board battery charger (see machine
components, item #13). The settings of On-board
battery charger had been set for the recommended
batteries type.
WaRnInG: The On-board battery
charger setting's change are to be completed
by authorized service centers only. Failure
to properly set will result in the batteries or
charger damage.
1. Transport the machine to a well ventilated area.
2. Turn the machine off.
3. If charging wet (lead acid) batteries check the
fluid level before charging.
4. Prop up the recovery tank by the support
stand (see machine components, item #27) for
ventilation.
5. Connect the charger's AC power supply cord to
a properly grounded receptable.
6. The charger will automatically begin to charge,
once the charging cycle begins, the indicator
lights will progress from red, yellow to green.
when the green indicator light comes on, the
charging cycle is done. Unplug the charger
cord.
NOTE: The machine will can not operate when
charging.
off-BoaRd BatteRy cHaRGeR (optIon)
1. Place charger and machine in a well ventilated
area.
2. Turn the machine off.
3. If charging wet (lead acid) batteries check the
fluid level before charging.
4. Prop up the recovery tank by the support
stand (see machine components, item #27) for
ventilation.
5. Connect the charger's AC power supply cord to
a properly grounded receptable.
6. Connect the charger's DC cord into the
machine's battery receptacle at the rear of the
machine.
7. The charger will automatically begin to charge
and will automatically shut off once the batteries
are fully charged.
8. Upon completion of charging, disconnect the
AC power supply cord first, and then disconnect
the charger from the machine.
WaRnInG: Before performing any
maintenance on the machine, be sure that
the power is turned off, or the batteries are
disconnected!
WARING: Repairs are to be completed
by Authorized service centers only. Any repairs
completed by unauthorized persons will avoid
the warrenty.
daIly maIntenance
1. Remove pad driver/ brush and clean with
approved cleaner.
2. Drain recovery and solution tanks completely
and rinse out with clean water. Visually check
the recovery tank for debris and clean out as
necessary.
3. Raise the squeegee assembly off floor and wipe
it down with a damp towel. Be sure to store the
squeegee in the up position.
4. Remove the float shut-off assembly and rinse it
out with clean water.
5. Clean machine with an approved cleaner and a
damp towel.
6. Recharge the batteries.
7. Check the condition of the squeegee blade
wiping edge, rotate blade if worn.
pReVentatIVe maIntenance