Ice i28BT, Operator'S & Parts Manual

Page: 11 / 38

11 ICE i28BT / i32BT
OPERATOR MANUAL
pRoBlem cauSe SolutIon
Machine will not
operate
Control handle bail not pulled Pull control handle bail
Batteries need to be charged Charge batteries
Bad battery(s) Replace battery(s)
Loose battery cable Tighten loose cable
Emergency stop button activated Reset Emergency stop botton
Main PCB fuse blown Contact ICE service center
Faulty key switch Contact ICE service center
Brush motor will
not operate
1-STEP scrub head up/down switch is off Turn on the 1-STEP switch
Battery meter lockout activated Recharge batteries
Brush motor fuse blown Replace 60A fuse
Brush motors over load Turn on / off the 1-STEP switch
Faulty control handle bail switch Contact ICE service center
Faulty brush motor or wiring Contact ICE service center
Worn Motor carbon brushes Contact ICE service center
Bad solenoid Contact ICE service center
Machine does
not propel
The Main Power Key Switch be Turned off,
the Control handle bail not pulled
Turn on the Key switch, Pull the control
handle bail
Tripped drive motor circuit breaker Reset drive motor circuit breaker button
Faulty transaxle motor or wiring Contact ICE service center
Worn Motor carbon brushes Contact ICE service center
Vacuum motor
will not operate
Tripped vacuum motor circuit breaker Reset vacuum circuit breaker button
Faulty vacuum motor or wiring Contact ICE service center
Worn Motor carbon brushes Contact ICE service center
Little or no
solution flow
Ball valve set too low or shut off Turn on the ball valve
Solution flow control knob set too low or
shut off
Adjust solution control flow knob
Clogged solution tank filter or solution
hose
Clean solution tank filter or flush out
solution hose
Clogged solution Solenoid valve Remove valve and clean
Poor water pick
up
Recovery tank is full Drain recovery tank
Loose drain hose cap Tighten cap
Clogged float shut-off screen located in
recovery tank
clean screen
Clogged squeegee assembly Clean squeegee assembly
Worn squeegee blades Replace or rotate squeegee blades
Incorrect squeegee blade deflection Adjust squeegee blade height
Loose vacuum hose connections Secure hose connections
Clogged vacuum hose Remove clogged debris
Damaged vacuum hose Replace vacuum hose
Recovery tank cover not in place Properly position cover
Damaged recovery tank cover seal Replace seal
Faulty vacuum motor Contact ICE service center
Low battery charge Recharge batteries
Short run time
Low battery charge Fully recharge batteries
Defective batteries Replace batteries
Batteries need maintenance See BATTERY MAINTENANCE
Faulty battery charger Repair or replace battery charger
Down pressure lever is set for extra scrub
head pressure
Lower down pressure lever
BaSIc tRouBleSHootInG