Ice i28BT, Operator'S & Parts Manual

Page: 6 / 38

6 ICE i28BT / i32BT
OPERATOR MANUAL
uncRatInG macHIne
Be sure and check packing carton for any damage.
Immediately report any damage to carrier. Check
the contents of package to ensure that the
following items are included:
• Machine
• 4-6V Batteries
• Squeegee assembly
• 2-Pad Drivers
InStallInG BatteRIeS
The batteries are already in the machine upon
delivery; However you will need to connect the
cables to the battery posts.
WaRnInG: Batteries emit hydrogen gas.
Explosion or fire can result from hydrogen
gas.Keep sparks and open flames away! Keep
battery compartment open when charging.
Recommended Battery spec:
4-6V, 260AH@20HR deep cycle batteries.
Max. batteries dimensions :
265mm (L) X 190mm (W) X 280mm (H)
1. Turn the main power key switch off.
2. Open recovery tank to gain access to battery
compartment.
3. Carefully place the batteries into the
compartment as shown in figure below. Place
the battery brace at the rear of the batteries.
do not dRop BatteRIeS Into
compaRtment!
4. Connect battery cables to posts in numbered
order as shown in drawing below.
Red to poSItIVe and BlacK to neGatIVe.
macHIne Set up
pRe-opeRatIon cHecKS
1. Sweep or dust mop the surface to be cleaned.
2. Check battery meter to make sure batteries are
fully charged. (See BATTERY CHARGING)
3. Check that squeegee is properly installed.
4. Check that brushes / pads is properly installed.
InStallInG BRuSHeS oR padS
1. Turn off the 1-STEP Scrub head up/down switch
(see machine components, item #7) and Raise
the Scrub head off the floor, then stop machine
on the level surface, remove the key and ensure
the machine is turned off.
2. If using the Pad Driver, first attach the
appropriate pad to the pad driver surface.
3. Align the pad driver or brush under the motor
hub and push it upward to engage.
4. To remove the pad driver or brush, raise
the scrub head and push the pad release
plunger (see machine components, item #38)
downward.
mountInG tHe SQueeGee aSSemBly
1. Lift the squeegee lift lever (see machine
components, item #24)to the upward position.
2. Mount the squeegee assembly to the squeegee
pivot bracket. make sure the knobs are
completely seated into the slots before securing
knobs.
3. Connect the vacuum hose to the squeegee
assembly. Loop the hose by using the hose clip
provided.
4. Check the squeegee blades for proper
adjustment.
MACHINE SET UP & INSTALLATION