23
Fit the rear shifter cable housing over the rear shifter
cable (right hand shifter). This is the longest cable
housing.
Thread the cable housing through all of the cable
guides located on the right side of the main frame also
using the cable to secure the chain tube hanging strap
as per the picture below:
Fit the long length of gear outer casing into the rear
derailleur. Clip the cable outer casing to the 2 guides
on the rear frame using the black plastic clips provided.
The third clip which is located behind the dropout will
not be used. This clip is only to be used if you are
fitting a rear-entry derailleur (like a Shimano), for
front-entry derailleurs the cable runs on the outside of
the swingarm.
Thread the inner wire cable through the outer casing
through to the rear derailleur.
Check that the rear derailleur is in the smallest cog
position. Rotate the rear shifter to the ‘9‘ position.
Turn the rear shifter barrel adjust clockwise fully into
the shifter, then back it off 1 full turn.
Thread the rear derailleur cable through the rear
derailleur housing stop and through the cable guide on
the fin. Pull the cable tight and position it under the
cable anchor washer. Tighten the 5 mm hex cable
anchor bolt to 35 – 45 in.lbs. (4 – 5 Nm).
Summary of Contents for 2009 Trice Q
Page 4: ...4 1 2 Overview...