17
2.8 Fit the seat to the lowest position
The seat is provided with 4 plastic SP-6 clamps. Two of these
clamps go around the bottom seat rail, and the other 2 go
around the top rail on the hard-shell seat or the 3
rd
rail
(counting from the bottom) on the mesh seat.
The 2 clips that go around the bottom rail are provided with
quick-release clamps. Place the clips on the bottom rail as
shown in the picture below, and then screw the quick-release
into the clip. Do not forget the small plastic spacer; the quick-
release will not work reliably without it.
The 2 clips that go on the upper rail are provided with M5
fasteners; quick-releases are not necessary as the seat mount
is held to the frame with a quick-release. Clip the SP-6
clamps to the rail and thread the bolts into place.
Set the 3 position upper seat mount in the lowest position (see photo). There is a quick-release skewer that goes
through the front hole on the top of the rear section. Place the seat onto the trike and see if it lines up with the
two mounting cups. Get the seat to fit by sliding the rear section in or out. Try to get the seat mount to sit at an
angle similar to the picture below right. Hold the seat on loosely with the 4 plastic clips supplied (quick-release
clips on the bottom, and bolted clips on the top) and then tighten the 2 lower quick-releases. Tighten the upper
seat mount quick-release, and then tighten the 2 upper plastic clip bolts. Check to see that the rear section is
still upright and then tighten the two rear section main clamp bolts evenly and tightly.
2.9 Fit the front boom to an approximate position.
Fit the front boom into the frame taking care not
to damage the plastic shim located inside the front
of the main frame. Position the boom at
approximately a hands span from the base of the
front derailleur post to the end of the main
cruciform.
Note: If you have purchased the optional quick-
release kit, please refer to the instructions for its
installation in Accessories Section of this manual.
Viewed from left hand side
Summary of Contents for 2009 Trice Q
Page 4: ...4 1 2 Overview...
