ELEVATION SERIES
INSTALLATION GUIDELINES
3
Clearance Requirements
Self-contained air cooled ice machines should have
a minimum of 6 inches (15cm) of clearance at the
rear, top, and sides for proper air circulation and
adequate space for serviceability.
Self-contained air-cooled ice machines exhaust air
out of the top and right side of the unit. By use of
SMART HARNESS™ technology, there are two
alternative air exhaust options. Option A (top
exhaust bias): minimum of 6 inches (15cm) of
clearance at the rear and top of the ice machine for
proper function at maximum operating conditions.
Option B (side exhaust bias): minimum of 6 inches
(15cm) of clearance at the rear and right side of the
ice machine with a minimum of 3 inches (7.5cm)
of clearance at the top for proper function at
maximum operating conditions.
Appropriate space should be allowed for proper
serviceability of the machine. Excess time to gain
access for serviceability is not covered under
warranty.
Stacking
Ice-O-Matic does not endorse stacking ice
machines.
Dispenser Application
A thermostatic bin control kit should be installed if
the CIM Cube ice machine is placed on a
dispenser. A bin top may or may not be required
and should be secured to the dispenser.
Electrical Specifications
Refer to the serial plate at the rear of the ice
machine to make sure proper voltage and circuit
breaker size have been supplied. Make sure the
machine is on a dedicated circuit. European
installations require that the electrical supply fixed
wiring must be provided with a disconnect means
having a separation of at least 3mm in all poles.
The ice machines are provided
without
an
electrical cord set and are designed and agency
approved to be permanently connected.
Units are not approved for GFI outlets
Caution:
Electrical connection must be made or a cord
installed by a
qualified electrician
or there is danger of
an electrical fire.
Adjustments
Level the machine within 1/8 inch in all directions.
Check the water in the Water Sump for proper
level.
Check the ice bridge for proper thickness.
Check the Water Regulating Valve adjustment if
water cooled.
Secure the machine on top of the bin or dispenser.
Attach the ice machine to the bin with the
mounting straps provided with the bin or dispenser.
Insure that the back of the ice machine is flush with
the back of the bin. Proper functioning of the Bin
Door requires the door, when it is opened, to be in
a stable position.
If the ice machine is too far forward on the bin, the
opened door may not be stable, resulting in an
unexpected closing of the bin door. If the ice
machine is to be mounted on a bin or dispenser
other than an Ice-O-Matic, refer to the
manufacturers instructions for machine mounting.
Ice-O-Matic will not be responsible for damage or
injury that results from unexpected closing of the
bin door as a result of the ice machine being too far
forward on the bin.
