ICD NeoGCP i7 PLUS+, User Manual

Page: 19 / 63

REV. N
NeoGCP
i7
PLUS+
- 19 -
6. Operation Sequence
Control Function According to Operation Mode. 6.1.
Functions BLOCK MANUAL AUTO FIRE
LCD Screen [BLOCK] [MANUAL] [AUTO] [FIRE-RUN]
LED Indicator
BLOCK : ON
MANUAL : OFF
AUTO : OFF BLOCK : OFF
MANUAL : ON
AUTO : OFF BLOCK : OFF
MANUAL : OFF
AUTO : ON BLOCK : OFF
MANUAL : ON
AUTO : ON
Mode Select
[MODE]
Button
[MODE] Button [MODE] Button
Arbitrary setup
impossible
Select Mode Non Applicable Possible Possible Possible
Gen-Set Start Impossible [START] Button Mains Off Continuous Input
Gen-Set Stop Non Applicable [STOP] Button Mains On No Input
Protection Partly Possible Possible Possible Possible
ACB Control Non Applicable
[CLOSE], [OPEN]
Button
Auto Auto
Cooldown Non Applicable Impossible Possible Possible
Change
Parameter
Possible Partly Possible Partly Possible Partly Possible
Fault History
Delete
Possible Impossible Impossible Impossible
MODBUS Comm Possible Possible Possible Possible
Operation Order 6.2.
- Sequence of generator operation as shown below.
Order Item Description
1 [READY] Ready to run
2 [PRE-CRANK]
When[PRE-CRANK TIME]is set, DO-CONFIG [C_PRE-CRANK] will
output
3 [CRANK-ON] Start
4 [CRANK-OFF] In case of start failure, standby until next start
5 [IDLE RUN] IDLE run
6 [BUILD-UP] Voltage, Frequency, and RPM waiting time to fall within rated range
7 [RUNNING] Nominal run status, Load run possible
8 [COOLDOWN] Cool down
9 [STOP] Stop
Ready 6.3.
- In order to be in [READY] status to start Gen-set, following 3 conditions must meet.
- If following conditions do not meet, status will switch to [CHECK] mode and,
[C_CRANK] will not output.
- If status is [CHECK] in [AUTO] mode, [F_FAIL TO STOP] Alarm situation will occur.