ICCONS
®
GAS TOOL GT-6 & GT-6ST USER MANUAL
8
March 2017 revision 1
4.6 Loading / Unloading The Pins
Caution !
•
Make sure the trigger is not held while
loading the pins.
•
Do not press on the surface ground while
loading.
Steps:
1. Load the pins into the slit in the rear of the
magazine until they reach in front of the nail
stopper.
2. Pull the follower holder to the bottom of the
magazine and release gently.
3. For removing the pins, pull the follower to the
bottom and allow the nails to slide to the nail
stopper.
4. Press the nail stopper behind the channel and
remove the pins from magazine channel.
4.7 Driving The Pins
Caution !
•
Please READ and UNDERSTAND the section
“General Safety Instructions” for personal and
working environment safety.
•
If you spot of any abnormality about the tool,
contact nearest authorized service agent for
inspection and repairing.
Steps:
1. Press the Nose of the contact arm against
working surface (90° against the surface)
firmly until you hear the fan motor is working.
2. Pull the trigger, the pins are driven to the
object.
3. Release the trigger and lift the tool.
4.8 Clearing Jammed Pins
Jamming of pins could be evident if users cannot
drive the fasteners properly, try following steps in
subsequent order.
Caution !
•
Place the tool on a flat surface prior to
releasing the magazine, (magazine may pop
off suddenly).
•
Read previous sections to fully understand
battery cartridge installation/removal and
unloading fasteners.
Steps:
1. Remove the pins, fuel cell and battery from
tool.
2. Pull the knob and rotate clockwise to release
magazine channel.
3. Clean any residue along the driving path in the
nose piece and pin guide.
4. To install the magazine, first engage the
magazine in the slot of the nose piece.
5. Push the connecting plate into the handle
until it “clicks”.
NOTE:
•
Do not release the magazine with fasteners
inside. The follower may pop the pins out and
cause injury.
•
Wear safety goggles, the jammed fastener
may jump out and hurt the user.
