ICCONS
®
GAS TOOL GT-6 & GT-6ST USER MANUAL
4
March 2017 revision 1
- Operator should carry out regular maintenance
(cleaning and lubrication) in accordance with
the operation manual to keep the tool in good
working order.
- The fastener driving tool should be serviced
properly and at regular intervals in accordance
with the operation manual.
1.3 Safety At Work
WARNING! Always assume the tool is loaded.
Never point any tool at yourself or at any other person.
- Make sure the workplace is clean and well lit.
- Stay alert, watch what are you doing, and use
common sense when operating the tool. Do not
use tool while tired or under the influence of
drugs, alcohol, or medication.
- The tool must be carried pointed downward while
moving locations. Never carry the tool with your
finger on the trigger.
- Never press your hand on the front of the tool.
The tool must be operated only when it is in
contact with the material to be fixed.
- The operator must be in a stable position when
using the tool. Operate the tool in the manner
that should the tool recoil, there is no risk of
injury to the operator.
- When using the tool, the operator and any
bystanders must wear appropriate eye and ear
protection.
- When not in use, remove the battery, fuel cell
and fasteners, return the fastener follower to
guide locking position, and return the tool to its
carrying case.
1.4 Safety For Handling Fasteners
- Do not load the fasteners with the trigger and/or
work-contacting element pressed.
- Ensure that you use the correct length of
fastener with the depth adjuster correctly set, so
that nails do not protrude when a fixing is made.
- Do not drive fasteners on top of other fasteners.
- Never drive fasteners into free space or areas
with concealed hazards. This will avoid a hazard
caused by free flying fasteners and excessive
strain of the tool. Take particular care when
nailing close to edges as fasteners can break-out
and deflect out of the substrate.
- If tool jams or misfires, always remove the
battery and fuel cell prior to examination of
the tool. If the problem persists stop operating
the tool, unload the fasteners, and contact the
manufacturer or authorized agents for service.
1.5 Safety For Gas-Operated Nailer Tool
- The tool must not be used in a combustible
environment.
- The tool must be used in well-ventilated areas.
Exhaust gases in a confined space can be
hazardous. Do not use the tool outside in the
rain or where excessive moisture in present.
- Keep the tool from heat sources as the
pressurized fuel cell could be damaged.
- Do not smoke when handling the fuel cell.
- Keep away from your face and eyes. Do not
inhale its content.
- The temperature of the tool may increase
depending on the firing frequency. Observe the
maximum cycle rates given in the operating
instructions.
2. THE USE OF FUEL CELL
DANGER !
KEEP FUEL CELL AWAY
FROM SMOKE AND FIRE
WARNING !
LIQUID GAS CAN CAUSE
INJURY IN THE CONTACT WITH THE
SKIN OR EYES
WARNING !
FUEL CELL CONTENTS
ARE EXTREMELY FLAMMABLE
WEAR EYE PROTECTION
USE PROTECTIVE HAND WEAR
