3
ICCONS
®
GAS TOOL GT-6 & GT-6ST USER MANUAL
March 2017 revision 1
1. GENERAL SAFETY INSTRUCTIONS
This appliance is not intended for use by person
with reduced physical, sensory and mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance by a
person responsible for their safety.
WARNING:
READ ALL SAFETY
WARNINGS AND ALL INSTRUCTIONS
TO REDUCE THE RISK OF INJURY,
READ THE INSTRUCTION MANUAL
BEFORE USE.
A. THE USE OF INTERNAL COMBUSTION,
GAS OPERATED NAILER TOOL
DANGER !
THE TOOL MUST NOT USED
IN A COMBUSTIBLE ENVIRONMENT
OR CONFINED SPACE.
WARNING !
CHECK THE SAFETY
YOKE IS FUNCTIONAL ON EVERY
OPERATION. It must reliably return
to its starting position.
WARNING !
KEEP TOOL AWAY FROM
SMOKE AND FIRE.
WEAR EAR PROTECTION
WEAR EYE PROTECTION
USE PROTECTIVE HAND WEAR
The
ICCONS® Gas Nailer
is referred to as “tool”
in this general safety instruction.
ICCONS®
is
referred to as “manufacturer” in this general safety
instruction.
1.1 Introduction
- Only those fasteners which are specified in the
operating instructions shall be used in the tool.
The tool, the fastener, the fuel cell and the
battery specified in the operating instructions
are to be considered as one unit safety system.
- Only spare parts specified by the manufacturer or
their authorized representative shall be used in
the service or repair of the tool.
- Repairs shall be carried out only by the
manufacturer or their authorized representative.
- Keep the tool, fasteners, fuel cell, battery and
charger out of the reach of children.
1.2 Safety Of The Fastener Driving Tool
- Check prior to each operation that the safety
mechanism is functioning properly. Rectify any
loose fasteners or defects on the tool before use.
- Only use the tool for nailing application for which
it was designed.
- It is not permitted to make any modification
to the tool, fuel cell or battery, other than
those specified by the manufacturer. If the
tool is weakened or damaged by: punching or
engraving; modification not authorized by the
manufacturer; guiding against templates made
of hard material; dropping or pushing across the
floor; use as a hammer; apply excessive force
of any kind; it should be taken to service and
inspected by the manufacturer or authorized
agents.
