iCanView110/110W User’s Guide
Rev.1.4 (Jan. 2005)
10 of 56
y
RS-232C (3 pins)
:
Used only by developers for development and production. Not for use by
end users.
y
DC12V, 1A
:
Power input of iCanView110. 12V/1A
y
DC-IRIS
: Plug in the cable attached on standard DC-Iris lens.
y
RS-485 and ALARM IN/OUT :
Is is used for connecting P/T/Z and alarm devices to
iCanView110. Pin assignments are :
Pin 1
RS-485 Negative (-) input
Pin 2
RS-485 Plus (+) input
Pin 3
Alarm In (-)
Pin 4
Alarm In (+)
Pin 5
Alarm Out (-)
Pin 6
Alarm Out (+)
RS-485 :
Used for connecting Pan/Tilt and Zoom devices having RS-485 interface
standard.
Alarm In :
It is used for connecting external alarm sensors such as the
infrared
sensors, heat sensor, magnetic sensors, etc.
Alarm Output :
It is used for connecting external alarm generators such as sirens,
flashing light, etc. When activated, relay output configures a closed circuit
y
VIDEO-IN :
Video input for video device(DVD, TV and etc) (composite NTSC, PAL, SECAM)
y
Factory Default Switch :
There is a switch provided for returning the network camera to
factory default state. Press the switch through a tiny hole above the Video-In connector using
sharp tool for a few seconds while power is applied.
y
Antenna Connector :
Connector for connecting 3dBi antenna supplied with iCanView110W
Refer to detailed information of Alarm in/Out to 6.1. ALARM-IN and ALARM-OUT in this guide
