iCanServer540R User’s Guide
2.3.2. Rear panel
Figure 2-2. Rear Panel of iCanServer540R
y
10/100base-T
: 10/100 Mbps Ethernet connector (RJ-45).
y
Line/Mic In (#1-#4) :
They are used to connect external audio source or microphone to
iCanServer540R. There are 4 Line/Mic. In connectors.
Use Standard stereo earphone jack for the connection.
y
Line Out : It is used for connecting external speakers with built in amplifier. Audio from
remote site is output through Line out in bi-directional audio mode.
Use Standard stereo earphone jack for the connection.
y
Video1- Video4 :
4 Video input (composite NTSC, PAL, SECAM)
y
Terminator : Enable termination by 75 Ohm resister for each video input when switched on.
Leave the terminator to ON position when no other device is sharing the same
video line. If the the specific video is sharing same video with other devices
and located at mid position along video line, leave the terminator to OFF
position.
y
COMP : Live video from the camera can be displayed on a local monitor with Composite
vidoe input. To use Composite video monitor, go to Admin -> Basic Set Up ->
Output Video Type to select “Composite”.
y
Factory Default Button :
It is used for resetting iCanServer540R to shipment state from
factory.
Factory Default Button is hidden underneath a tiny
hole located at the upper left part of
P/T/Z RS-232 & RS-
485
connector. Press the button by tools having sharp tip.
y
P/T/Z RS-232 & RS-485 : It is used for connecting P/T/Z device with RS-232 or RS-485
interface standard. Pin assignments are
Pin 2 – RS-232 In
Pin 3 – RS-232 Out
Pin 5 – RS-232 GND
Pin 8 – RS-485 Negative (-) input
Rev.1.0 (Nov. 2006)
10
