iBridge IBR-ITAB, User Manual

Page: 18 / 68

18
Disarming the System
1
Enter your premises through the Entry/Exit door. The keypad will sound a steady tone to remind you to disarm the system
before your Entry Delay time expires. The keypad automatically appears.
2
Enter your User Code and tap
U
.
The Keypad Window will read " System Ready ", indicating that the system has been
disarmed. If you enter an invalid code, the keypad will beep 4 times, signifying an error. Re-enter your code immediately.
10 seconds before Entry Delay expires, the keypad will emit a pulsing warning tone.
Alarm Indication / Silencing an Alarm
If "ALARM" is displayed, an alarm occurred while you were out. Proceed with caution! If you suspect that an intruder may still be on the
premises, leave immediately and call authorities from a neighbor's telephone.
To silence an audible alarm:
1 At the keypad screen, enter your code and tap
U
. After the system is disarmed, the window will continue to display
"ALARM" followed by the zone(s) violated.
2
To reset the display, note the zones violated, then tap
C
.
Ambush
(Optional) Your Ambush Code Type is: ‰ TYPE 1 (Prefix) ‰ TYPE 2 (Unique)
My Ambush Code is ___________________
If an intruder forces you to disarm your system, enter your Ambush Code and tap
U
.
There are two types of Ambush Codes: (1) A 2-
digit code (prefix) entered just prior to your normal User Code and (2) A separate and unique User Code.
•
Example Type 1 (Prefix): If your User Code is 1234 and your Ambush Code is 99, tap
991234
U
.
•
Example Type 2 (Unique): If your User Code is 1234 and your Ambush Code is 8899, tap
8899
U
Using your Ambush Code will send a silent alarm to the central station. The window will display "SYSTEM READY" as if the system
were normally disarmed. There will be no indication that a silent alarm has been sent.
D I S AR M I N G ( T U R N I N G O F F T H E AL AR M ) W H E N R E T U R N I N G