IBM TotalStorage Ultrium T800, Operator'S Manual

Page: 110 / 148

Removing a Fibre Channel Tape Drive from an Enclosure
To remove a fibre channel drive from an enclosure, perform the following steps:
1. Ensure that the tape drive does not contain a tape cartridge.
2. Deconfigure the drive from the server, switch, or hub (for instructions, see the
documentation for these devices).
3.
Turn off the power to the enclosure. Disconnect the power cable from the
enclosure and the electrical outlet.
4. Disconnect the internal power cable from the power connector (see
1
in
“Rear View of the Fibre Channel Drive” on page 4).
5. If connected, disconnect the internal LDI (RS-422) cable from the LDI (RS-422)
connector (see
7
in “Rear View of the Fibre Channel Drive” on page 4).
6. Disconnect the internal fiber cable from the Fibre Channel connector (see
5
in “Rear View of the Fibre Channel Drive” on page 4).
7.
Disconnect the LID/status connector (see
3
in “Rear View of the Fibre
Channel Drive” on page 4).
8. Disconnect the FC configuration/status connector (see
4
in “Rear View of
the Fibre Channel Drive” on page 4).
9. Remove the mounting screws from the side brackets of the chassis (see
2
in
Figure 10 on page 23).
10.
Remove the tape drive from the enclosure.
11. To reassemble, reverse these steps.
94
IBM TotalStorage Ultrium Tape Drive
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|