IBM TotalStorage Ultrium T800, Operator'S Manual

Page: 109 / 148

Servicing the Drive
Removing a SCSI Drive from an Enclosure
To remove a SCSI drive from an enclosure, perform the following steps:
1. Ensure that the drive does not contain a tape cartridge.
2. Deconfigure the drive from the server (for instructions, see your server’s
documentation).
3. Turn off the power to the enclosure. Disconnect the power cable from the
enclosure and the electrical outlet.
4. Remove the cover of the enclosure.
5. Disconnect the internal power cable from the power connector (see
3
in
Figure 4 on page 3).
6. If connected, disconnect the internal LDI (RS-422) cable from the LDI (RS-422)
connector (see
4
in Figure 4 on page 3).
7. Disconnect the internal SCSI cable from the SCSI connector (see
1
in
Figure 4 on page 3).
8.
Perform one of the following procedures on the SCSI ID connector (see
2
in
Figure 4 on page 3):
v If your enclosure uses an internal SCSI ID switch, disconnect it from the
SCSI ID connector.
v If your enclosure uses jumpers to set the SCSI ID, do not remove them from
the connector.
9. Remove the mounting screws from the side brackets of the chassis (see
2
in
Figure 10 on page 23).
10.
Remove the drive from the enclosure.
11. To reassemble, reverse these steps.
© Copyright IBM Corp. 2004, 2005
93