IBM System Storage DS3300, Installation, User'S, And Maintenance Manual

Page: 37 / 140

Attention
Before you power-on the storage subsystem, it must contain at least four
drives. If at least four drives are not installed in each attached storage
expansion enclosure and in the DS3300 storage subsystem, when you
power-on the DS3300 and its attached storage expansion enclosures,
your standard storage partition key might be lost and you must
regenerate it, using instructions at http://www.ibm.com/storage/fasttkeys/.
In addition, the resulting insufficient load to the enclosure power supplies
might cause them to intermittently appear to have failed, falsely indicating
that the power supplies are bad. All drives in the DS3300 storage
subsystem and the connected storage expansion enclosures must
contain no prior configuration data.
7. Use SAS cables to cable the DS3300 to the storage expansion enclosures.
See “Connecting storage expansion enclosures to the DS3300” on page 25.
8. Complete one of the following cabling tasks to enable management of the
DS3300 configuration:
v If you are using out-of-band management, cable the DS3300 Ethernet ports
to either the management workstation or the host.
v
If you are using in-band management, cable the DS3300 to the hosts. See
“Connecting hosts to the DS3300” on page 36.
9. Connect the power cables for the DS3300. See “Cabling the DS3300 power
supplies” on page 41.
10. Power-on the attached storage expansion enclosure and the DS3300 storage
subsystem, using the procedure in “Turning on the storage subsystem” on
page 44.
11. Install the DS3000 Storage Manager Version 2 software on the management
workstation (for out-of-band management) or on the host (for in-band
management). See the
IBM System Storage DS3000 Storage Manager 2
Installation and Support Guide for the management-workstation or host
operating system for instructions for installing the DS3000 Storage Manager
Version 2 software.
12. Use the DS3000 Storage Manager software to verify the configuration.
13. Review and perform the procedures in “Performing the DS3000 Health Check
process” on page 43.
Handling static-sensitive devices
Attention: Static electricity can damage the storage subsystem and other
electronic devices. To avoid damage, keep static-sensitive devices in their
static-protective packages until you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following
precautions:
v
Limit your movement. Movement can cause static electricity to build up around
you.
v Handle the device carefully, holding it by its edges or its frame.
v
Do not touch solder joints, pins, or exposed printed circuitry.
v Do not leave the device where others can handle and damage it.
Chapter 2. Installing the storage subsystem
19