IBM SUREMARK TF6, User Manual

Page: 154 / 244

n=01 Set Invert Mode
Default:
n = 00
Remarks:
This is valid in the customer receipt station only.
Set or cancel emphasized printing
EIA-232 Syntax:
ESC G n or X'1B;47;n'
where:
n=00 Cancel Emphasized Mode
n=01 Set Emphasized Mode
Default:
n = 00
Remarks:
This must be at the beginning of a print-line in the document portrait station.
It is enabled for the entire line.
Select maximum print speed
EIA-232 Syntax:
ESC ? n or X'1B;2F;n'
where:
n=00 52 lines per second
n=01 35 lines per second
n=02 26 lines per second
n=03 15 lines per second
Default:
n = 00
Remarks:
v
In the cash receipt station, the printing will slow down to the maximum
selected speed. This will increase the quality of the printing and lower the
current draw from the power supply when printing high density images,
such as dark logos.
v
This is the maximum speed being selected, so the dot utilization
algorithms can still slow the speed further when necessary.
v If MCT 11 hex (17 dec), bit 11 has been set to a value of zero (maximum
speed of 35 lps), then this command will not have an effect on the
maximum print speed (the MCT value takes precedence).
v
This command does not affect the document station.
v This command is not supported in TI-1/2 printers.
v
This command used to be called set/cancel high quality print mode
and only supported parameter byte values of 0 and 1. Code level 40
added parameter byte values of 2 and 3.
Updated April 2, 2009
132
SureMark Printers User’s Guide