IBM StorageSmart DF1100J, Operator'S Manual

Page: 26 / 52

4. Verify that the disk drive module that you have just installed is aligned with
the sides of the unit, and that no gap exists between this module and the
modules that are next to it.
Verify also that the front edge of this disk drive module aligns with the front
edges of the modules next to it.
If the disk drive module is not correctly aligned, remove it (see step 1 on
page 18) and reinstall it (steps 2 through 3 above).
5. The green Activity
«1¬
light comes on and then goes off. If the amber Check
«2¬
light comes on, verify that the new disk drive module has been correctly
installed. If it has been correctly installed, refer to the SANArray Manager Client
Software for Mylex External Disk Array Controllers: Installation and User Manual for
guidance on how to obtain information about the problem.
6. Add the new disk drive module into your system software configuration, using
the system programs.
Refer to the SANArray Manager Client Software for Mylex External Disk Array
Controllers: Installation and User Manual for guidance on how to do this.
Figure 18. Disk Drive Module Lights
16
ProFibre Storage Array: Operator’s Guide