![background image](http://html1.mh-extra.com/html/ibm/storagesmart-df1100j/storagesmart-df1100j_operators-manual_608695023.webp)
Chapter 2. Adding Disk Drive Modules
This chapter describes how to add disk drive modules to a unit in a ProFibre
Storage Array that is already installed as part of your system.
You can do this only if:
1.
You are authorized by your organization.
2.
You have the correct disk drive module. Refer to Figure 13. This disk drive
module has, at the front, a handle
«1¬
that can be pulled upward to open. The
capacity of a disk drive module is shown on a label
«2¬
at the front of the disk
drive module. The label is shown in more detail in Figure 12 on page 11.
Attention:
Disk drive modules are fragile. Handle them with care. Keep them well
away from strong magnetic fields.
You do not need to remove power from the unit when adding a disk drive
module.
After you have added a disk drive module to the unit, you must add it into your
system software configuration by using the system programs.
Refer to the SANArray Manager Client Software for Mylex External Disk Array
Controllers: Installation and User Manual for guidance on how to do this.
Figure 13. Disk Drive Module Handle and Label
© Copyright IBM Corp. 2001
13
Summary of Contents for StorageSmart DF1100J
