IBM SAN04B-R - System Storage Router, Installation, Service And User Manual, Page: 56 / 103

The license key is a string of approximately 16 uppercase and lowercase letters
and digits. Case is significant. The key is an encrypted form of the system
WWN and the products licensed to run on this system.
3. Enter the licenseAdd command, followed by the license key enclosed in
quotation marks, as shown in the following example.
APswitch:admin> l icenseadd "aBcDeFGh12345K"
License key aBcDeFGh12345 added
Enter the license key into the system exactly as issued. If you enter it
incorrectly, the license might be accepted, but it will not function.
4. After entering the license key, use the licenseShow command to verify that it is
valid. If a licensed product is not displayed, the license is invalid.
Note: After you enter a license, the licensed product is available immediately;
the system does not need to be rebooted.
Removing a license key
To remove a license from the router, complete the following steps.
1. Log in as
admin
.
2. Enter the licenseRemove command, followed by the license key enclosed in
quotation marks, as in the following example.
APswitch:admin> licenseremove "bQebzbRdScRfc0iK"
removing license key "bQebzbRdScRfc0iK"
3. Save the license key information in case you want to reinstall it in the future.
4. After removing the license key, the router must be rebooted.
5. Use the licenseShow command to verify that the license key has been
removed.
28
SAN04B-R Installation, Service, and User’s Guide