IBM RackSwitch G8000, Installation Manual

Page: 38 / 86

1
2
3
5. Connect all cables.
6. Initialize the switch, see Chapter 4, “Initializing the RackSwitch,” on page 45.
Attention: If this is a switch replacement, make sure the vital product data
(VPD) is updated to avoid losing the licensed electronic entitlement data of the
RackSwitch. For more information, see “Configuring Vital Product Data after a
switch replacement” on page 43.
Installing the RackSwitch in an IBM iDataPlex rack
This section describes how to install the RackSwitch G8000 in an IBM iDataPlex
rack. The iDataPlex mounting kit allows the switch to be mounted either vertically or
horizontally. For information about mounting the RackSwitch in other rack types,
see the following sections:
v
“Installing the RackSwitch in a standard equipment rack” on page 20
v
“Installing the RackSwitch in an IBM System x
®
or Power rack” on page 24
The iDataPlex rack mount kit must be purchased separately. The following table
lists the parts included in the iDataPlex mounting kit.
Table 16. iDataPlex rack mount kit parts
Item number Description Quantity
1 Label 1
2 M6 locking washers 8
3 M6 screws 8
4 M6 clip nuts 8
5 M4 screws 16
6 Switch front bracket 2
7 Switch rear bracket 2
8 Rear mounting bracket 2
Attention: For earthquake stability, mount the switch in a 4-post rack.
22
IBM System Networking RackSwitch G8000: Installation Guide