IBM PC 300GL Type 6563, User Manual

Page: 73 / 190

6. Select Low Power Entry Activity Monitor and press Enter.
7. Set to Enabled or Disabled devices you want to be monitored for
power management.
Note: If all devices are set to disabled, you must restart the computer
to wake the system.
8. Press Esc three times to return to the Configuration/Setup Utility
program menu.
9. Select Save Settings from the Configuration/Setup Utility program
menu, then press Esc and follow the instructions on the screen.
Setting automatic power-on features
You can use the automatic power-on features on the Power Management
menu to enable and disable features that automatically turn on your
computer. You must also select the startup sequence you want to use for
the type of power-on event you select.
Ÿ
Wake on LAN: If you have remote network-management software and
a Wake on LAN-supported network adapter, you can use the
IBM-developed Wake on LAN feature. When you set Wake on LAN to
Enabled
, your computer will turn on when it receives a specific signal
from another computer on your local area network (LAN). For more
information, see the documentation that comes with your network
adapter.
Ÿ
Serial Port Ring Detect: If your computer has an external modem
connected to a serial port and you want the computer to turn on
automatically when a ring is detected on the modem, set this feature to
Enabled
. The modem must also support this feature.
Ÿ
PCI Modem Ring Detect: If your computer has a PCI modem and you
want the computer to turn on automatically when a ring is detected on
the modem, set this feature to Enabled.
Ÿ
Wake Up on Alarm: With this feature, you can specify a date and time
at which the computer will be turned on automatically. This can be
either a single event, a daily event, or a weekly event.
Ÿ
PCI Wake Up: If this setting is enabled, your computer turns on in
response to wake up requests from PCI devices that support this
feature.
To set automatic power-on features, follow these steps:
1. Start the Configuration/Setup Utility program (see “Starting and using
the Configuration/Setup Utility program” on page 39).
2. Select Power Management and press Enter.
3. Select Automatic Power On and press Enter.
Chapter 4. Configuration/Setup Utility program
55