IBM NETVISTA 2251, Hardware Maintenance Manual

Page: 109 / 152

9. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu.
10.
To exit from the Configuration/Setup Utility program, press Esc and follow
the instructions on the screen.
Automatic Power-On features
The Automatic Power-On features within the Power Management menu allow you
to enable and disable features that turn on the computer automatically.
v
Serial Port A Ring Detect : With this feature set to Enabled and an external
modem connected to serial port (COM1), the computer will turn on
automatically when a ring is detected on the modem.
v
PCI Modem Ring Detect : With this feature set to Enabled , the computer will
turn on automatically when a ring is detected on the internal modem.
v
PCI Wake Up: This feature allow PCI cards that support this capability to wake
the system.
v
Wake Up on Alarm : You can specify a date and time at which the computer will
be turned on automatically. This can be either a single event or a daily event.
v
Wake on LAN : If the computer has a properly configured token-ring or Ethernet
LAN adapter card that is Wake on LAN-enabled and there is remote network
management software, you can use the IBM-developed Wake on LAN feature.
When you set Wake on LAN to
Enabled , the computer will turn on when it
receives a specific signal from another computer on the local area network
(LAN). For further information, see “Wake on LAN” on page 102.
Network settings
This section applies only to computers that are linked to a network.
The Configuration/Setup Utility program includes settings that can be enabled and
disabled to configure the network interface in the computer. These settings are the
following:
v
Flash over LAN (Update POST/BIOS over Network)
v
Wake on LAN
Chapter 8. Additional Service Information
101