5.
To install the chassis in an open-frame rack, install a mounting screw into each
of the open mounting holes aligned with the rack, starting from the bottom.
6.
Visually inspect the alignment of the chassis. If the chassis is installed properly
in the rack, all the mounting screws on one side of the rack should be aligned
with the mounting screws on the opposite side and the chassis should be level.
Figure 7: Lift the Chassis into the Rack
OK
MASTER
FAN
ONLINE
OFFLINE
0
1
1
0
FAIL
FAIL
PEM
FAIL
FAIL
FAIL
FAIL
FAIL
FAIL
ESD
OK
OK
OK
OK
OK
OK
OK
2
3
4
5
ACO/LT
YELL
OW ALAR
M
RED ALAR
M
NC
NO
C
NC
NO
C
REO
RE1
0 1 2 3
5
4
3
2
1
0
1
0
g004249
Reinstall Components
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see the
IBM Ethernet Appliance J56S Hardware Guide
.
2.
Slide each component into the chassis evenly so that it does not become stuck
or damaged.
3.
Tighten the captive screws or lock any levers for each component installed.
NOTE:
Make sure that all empty slots are covered with blank panels before operating
the device.
12
■
Step 3: Install the Device
IBM Ethernet Appliance J56S Getting Started Guide
