IBM InfoPrint 6500, User Manual

Page: 126 / 334

ASCII Data Port
This option sets the port number for ASCII print jobs. The data port number needs
to match your host system setting.
v
9100 (default)
v
0 - 65535
IPDS Data Port Number
This option allows you to set the port number for IPDS print jobs. The port
number needs to match your host system.
v 5001 (the default)
v
0 - 65535
Keep Alive Timer
This is the time that the Keep Alive Timer will run. With the Keep Alive Timer on,
the top connection will stay connected even after the print job has terminated.
v
3 Minutes (default)
v
2 - 10 Minutes
Ethernet Speed
The Ethernet Speed menu allows compatibility with different systems and
networks. The factory default is Auto Select.
v
Auto Select (the default). This setting tells the 10/100Base-T NIC to perform an
auto detection scheme and configure itself to be 10 Half Duplex, 10 Full Duplex,
100 Half Duplex, or 100 Full Duplex.
v
10 Half Duplex . This setting tells the 100 Base-T NIC to communicate at 10
Megabits per second using half duplex.
v
10 Full Duplex . This setting tells the 100 Base-T NIC to communicate at 10
Megabits per second using full duplex.
v
100 Half Duplex . This setting tells the 100 Base-T NIC to communicate at 100
Megabits per second using half duplex.
v 100 Full Duplex . This setting tells the 100 Base-T NIC to communicate at 100
Megabits per second using full duplex.
Job Control
The job control mode has three options:
v Standard
(default). The NIC waits for the printer to finish receiving the current
job before sending another job. The status line shows “done” when the job is
completely received by the NIC. This is the default.
v
Enhanced . The NIC waits for the printer to finish receiving the current job
before sending another job. The status line shows “done” when the job is fully
printed.
v
Off . No job synchronization between the NIC and the printer.
112
Infoprint 6500 User’s Manual