IBM INFO PRINT 3000, Operator'S Manual

Page: 320 / 346

Table 30. SRC Messages (continued)
Code Message Text Type (Printer Error unless
noted otherwise)
D081 MIC permanent error
D082 MIC failure during diagnostics
D083 MIC failure during initial power on EPROM diagnostics
D084 MIC microcode error
D090 MIC failure during attention light test
D091 MIC failure during printer activate test
D092 MIC failure during printer interface test
D093 MIC failure during alarm test
D095 MIC failure during intelligent interface wrap test
D096 MIC failure during coupled interface wrap test
D097 MIC failure during pre/postprocessor run motor test
D098 MIC failure during pre/postprocessor offset test
D099 MIC failure during printer dormant test
D201 Fuser warming timeout
D202 Pre/postprocessor PAUSE was active more than 100 seconds.
D203 Pre/postprocessor STOP line became active.
D204 Pre/postprocessor NOT READY line became active.
D205 PAGE COMPLETE timeout
D206 Ready was selected before threading forms Intervention Required
D208 Communication with the MIC has failed
D20A Pre/postprocessor BUSY was active too long.
D20B Incorrect printer speed
D20C Form length mismatch
D20D Form width mismatch
D20E Pre/postprocessor processor power is off.
D20F Undefined character received by intelligent interface
D210 Illegal position received by intelligent interface
D211 Illegal media modification received by intelligent interface
D212 MICR data received while MICR option disabled
D213 Availability of intelligent postprocessor has changed
D214 Intelligent postprocessor forms jam
D215 MIC to intelligent interface communications failure
D216 Intelligent interface response timeout
D217 Command rejected by intelligent interface
D218 Intelligent interface responded, but is not in configuration
D219 Intelligent interface type not recognized
D21A Intelligent postprocessor restarted
288
InfoPrint 3000 Operator’s Guide