IBM IBM-3415, Installation And Operating Manual

Page: 15 / 24

Connecting the Phone to the Wall Jack
Note: This unit can be desk or wall mounted.
1. Insert the pedestal into the slots on the bottom of the base and slide up to lock in place.
The pedestal is reversible for desk or wall mounting.
2. Connect the telephone line cord to the "TEL LINE" jack and to a telephone outlet.
3. Connect the AC power adapter to the 9V DC jack and to an AC outlet.
4. Raise the antenna vertically.
Note: Use only the supplied AC power adapter. Do not use any other AC power adapter.
Connect the AC power adapter to a continuous power supply. Place the phone close
to the AC outlet so that you can plug in the AC power adapter easily.
Tip: If your telephone outlet is not modular, contact your telephone service company for
assistance.
BASE
P E D E S TA L
11
TELEPHONE SETUP
Use only with class 2
Power Source 300mA
P/T DC-9V TEL LINE
Battery Installation
To install the 3.6V 600mAh cordless handset battery pack:
1. Slide open the battery compartment door on the back of
the handset.
2. Insert the battery pack so that its connectors line up with
those built into the handset.
3. Close the battery compartment door.
4. Place the handset on the base unit cradle.
5. Once you have installed the battery pack and placed the
handset on the base you will hear a tone indicating the
handset has connected with the base and will
successfully charge.
6. IMPORTANT: Charge the battery pack for at least 12
hours before using the handset the first time.
7. The CHARGE/IN USE LED on the base will light when the
handset is properly making contact with the charge
terminals.
Battery Duration
A fully charged battery lasts for approximately:
• 8 hours when you use the handset continuously (talk time)
• 7 days when the handset is not in use (standby)
When the Battery Needs Charging
• The phone will beep and the “ IN USE ” LED will flash
When to Purchase a New Battery Pack
If the battery lasts only a few minutes even after a full charge,
the usable life of the battery has expired and needs to be
replaced. Contact the TT Systems LLC customer support center
at
800-955-1009 or on the Internet at www.ttsystems.com.
Reversible Handset Charging
The handset can be placed face up or face down and the handset will charge. The
CHARGE/IN USE LED located on the base will light to insure that handset is charging properly.
BATTERY INSTALLATION
14
IN USE
3.6 volt Ni Cd Battery