IBM HC10 - BladeCenter - 7996, Service Manual

Page: 36 / 114

Installing the blade workstation cover
To install the blade workstation cover, complete the following steps.
Statement 21:
CAUTION:
Hazardous energy is present when the blade workstation is connected to the
power source. Always replace the blade cover before installing the blade
workstation.
Blade-cover
release
Blade-cover
release
Cover
pins
Attention: You cannot insert the blade workstation into the BladeCenter unit until
the cover is installed and closed. Do not attempt to override this protection.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 13.
2. Lower the cover so that the slots at the rear slide down onto the pins at the rear
of the blade workstation. Before closing the cover, check that all components
are installed and seated correctly and that you have not left loose tools or parts
inside the blade workstation.
3. Pivot the cover to the closed position until it clicks into place.
4. Install the blade workstation into the BladeCenter unit (see “Installing the blade
workstation in a BladeCenter unit” on page 17 for instructions).
20
BladeCenter HC10 Type 7996: Problem Determination and Service Guide