IBM eServer xSeries 335 Type 8676, Hardware Maintenance Manual And Troubleshooting Manual

Page: 89 / 178

Riser card
Complete the following steps to remove the riser card.
Note:
v Read “Installation guidelines” on page 39.
v
Read the safety notices at “Safety information” on page 123.
v Read “Handling electrostatic discharge-sensitive devices” on page 126.
1. Turn off the server and any attached devices.
2. Disconnect power cords and external cables from the back of the server.
3. Remove the server from the rack.
4. Remove the cover (see “Removing the cover and bezel” on page 46).
5. Remove adapters (see “Working with adapters” on page 47).
System board
Riser card
6. Pull up gently on the riser card until it detaches from the server.
To replace the riser card, reverse the preceding steps.
Chapter 5. Service replaceable units
79