IBM eServer xSeries 205 Type 8480, Hardware Maintenance Manual And Troubleshooting Manual

Page: 77 / 168

Chapter 5. Field replaceable units
The following information describes procedures for removing and installing certain
components inside the system. Only a qualified service technician is authorized to
access the components described in this section.
Important: The field replaceable unit (FRU) procedures are intended for trained
servicers who are familiar with IBM xSeries products. See the parts
listing in “System” on page 110 to determine if the component being
replaced is a customer replaceable unit (CRU) or a FRU.
Note: Before servicing this system, read“Installation guidelines” on page 38. .
Removing the front bezel
The following illustration shows how to remove the bezel from the server.
Note: The illustrations in this document might differ slightly from your hardware.
Do the following to remove the bezel:
1. Review the information in “System reliability considerations” on page 33.
2. Turn off the server and peripheral devices and disconnect all power cords and
then all external cables.
3. Remove the side cover (see “Removing the side cover” on page 40).
4. Press the bezel-release latch at the top of the server to disconnect the top of
the bezel from the server.
© Copyright IBM Corp. 2002
67