IBM eServer xSeries 205 Type 8480, Hardware Maintenance Manual And Troubleshooting Manual, Page: 53 / 168

v Your server uses a rotational interrupt technique to configure PCI adapters.
Therefore, you can install a variety of PCI adapters that currently do not support
sharing of PCI interrupts.
v PCI slots 1 through 5 are on PCI bus 2.
The system scans the AGP slot and PCI expansion slots 1 through 5 to assign
system resources. Then, the system starts devices in the following order, if you
have not changed the default startup sequence: the AGP slot, PCI expansion
slots 1 and 2, system board integrated drive electronics (IDE) or SCSI devices,
and then PCI expansion slots 3 through 5.
v
The optional Remote Supervisor Adapter must be installed in PCI slot 1.
v For a list of supported options for your server, go to
http://www.ibm.com/pc/support/ on the World Wide Web.
Installing an adapter
Complete the following steps to install an adapter.
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details about handling these devices, see
“Handling static-sensitive devices” on page 38.
1. Review the information in “Safety information” on page 117.
2. Turn off the server and all attached devices, and disconnect all external cables
and power cords; then, remove the side cover. See “Removing the side cover”
on page 40.
Note: Check the instructions that come with the adapter for any requirements,
restrictions, or cabling instructions. It might be easier to route any
cables before you install the adapter.
3. Remove the frame-support bracket. See “Removing the frame-support bracket”
on page 41.
4. If you are installing a full-length adapter, rotate the front adapter-retaining
bracket to the open position.
5. Rotate the rear adapter-retaining bracket to the open (unlocked) position, and
remove it from the server.
6. From the rear of the server, press on the slot cover. Grasp it and pull the
expansion-slot cover out of the expansion slot. Store it in a safe place for
future use.
Attention: Expansion-slot covers must be installed on all vacant slots. This
maintains the electronic emissions standards of the server and ensures proper
ventilation of server components.
7. Set any jumpers or switches on the adapter or system board as described by
the adapter manufacturer.
Chapter 4. Installing options
43