IBM eServer xSeries 135, User Reference Manual

Page: 88 / 144

76
IBM xSeries 135: User’s Reference
00180200 A PCI adapter has requested an I/O address that is not available, or the PCI adapter might be
defective.
Action: 1. Make sure that the I/O addresses for the PCI adapter and all other adapters are
set correctly in the Configuration/Setup Utility program. See “Using the
Configuration/Setup Utility program” on page 12.
2. If the I/O port resource settings are correct, the PCI adapter might be defective.
Call for service.
00180300 A PCI adapter has requested a memory address that is not available, or the PCI adapter might be
defective.
Action: 1. Make sure that the memory addresses for all other adapters are set correctly in
the Configuration/Setup Utility program. If the memory resource settings are
not correct, change the settings. “Using the Configuration/Setup Utility
program” on page 12.
2. If the memory resource settings are correct, the PCI adapter might be defective.
Call for service.
00180400 A PCI adapter has requested a memory address that is not available.
Action: If all memory addresses are being used, you might need to remove an adapter to
make memory address space available to the PCI adapter. Disabling the adapter
BIOS on the adapter might correct the error. Refer to the documentation that is
provided with the adapter.
00180500 A PCI adapter ROM error occurred.
Action: Remove the PCI adapters. If you can start the server without the adapters, reinstall
each adapter one at a time and retest after each is reinstalled. When an adapter fails,
replace it.
If you cannot isolate and correct the problem, call for service.
00180600 A PCI-to-PCI bridge error occurred. More than one PCI bus tried to access memory below 1 MB.
Action:
Remove the PCI adapter that has the PCI bridge. If you can start the server without
the adapter, reinstall and retest the adapter. If the adapter fails, replace it.
If you cannot isolate and correct the problem, call for service.
00180700 xxxxyyyy System board PCI device does not respond or disabled by user. (Where xxxx is the PCI
vendor ID and yyyy is the PCI device ID).
Action: Start the Configuration/Setup Utility program, select Devices and I/O Ports, and
make sure that the device is enabled. See “Using the Configuration/Setup Utility
program” on page 12. If the problem persists, call for service.
00180800 An unsupported PCI device is installed.
Action: Remove the PCI adapters. If you can start the server without the adapters, reinstall
each adapter one at a time and retest after each is reinstalled. When an adapter fails,
replace it.
If the problem persists, call for service.
00181000 PCI error.
Action: Remove the PCI adapters. If you can start the server without the adapters, reinstall
each adapter one at a time and retest after each is reinstalled. When an adapter fails,
replace it.
If the problem persists, call for service.
Table 12. POST error messages
POST message Description