IBM eServer 370 xSeries, Installation Manual

Page: 38 / 92

Installing a processor
Your xSeries 370 server comes with at least one processor installed on the
standard processor daughterboard. When you install one or more additional
processors, your server can operate as a symmetric multiprocessing (SMP) server.
With SMP, certain operating systems and application programs can distribute the
processing load among the processors. This enhances performance for database
and point-of-sale applications, integrated manufacturing solutions, and other
applications.
Note: To ensure that your operating system supports multiprocessing operations,
load the appropriate multiprocessor option software in your operating
system programs.
Your server supports a maximum of eight Intel Pentium III Xeon processors. For a
list of supported operating systems, see http://www.ibm.com/pc/us/compat/ on the
World Wide Web.
Before you begin:
Thoroughly review the documentation that comes with the processor, so
that you can determine whether you need to update the xSeries 370 server
basic input/output system (BIOS). Verify that you have the latest BIOS level
for your server by accessing http://www.ibm.com/pc/us/compat/ on the
World Wide Web. Refer to the “Getting Help, service and information”
section of the
User's Reference on the IBM xSeries Documentation for the
appropriate World Wide Web addresses.
If you plan to use the processor serial-number security feature, you must
change the setting of the
Processor Serial Number Access menu choice
in the Advanced Setup menu of the Configuration/Setup Utility program.
The default value is
Disabled ; change this value to Enabled .
Notes:
1. The illustrations in this section might differ slightly from your hardware.
2. To ensure proper server operation, when you install an additional processor,
use processors with the same cache size and core frequency as those of the
currently installed processor.
3. If you replace the processors in your server with processors of a different
speed, be sure the processor core frequency selection jumper block is set
correctly. (See “Processor-controller board jumpers” on page 34 for more
information. For a list of supported processor speeds, see
http://www.ibm.com/pc/us/support/ on the World Wide Web.)
4. To maintain signal quality and system reliability, either a processor or a
processor terminator card must be installed in each processor connector. A
processor must be installed in processor connector A1 on the standard
processor daughterboard (A).
5. You will need to install a second processor daughterboard if you plan to use
more than four processors in your server.
6. If you are installing an optional processor daughterboard (B), you must also
install the two cache coherency filter cards in the two adjacent, vertical slots
between the two processor daughterboards on the processor controller board.
26
xSeries 370 Installation Guide