IBM eServer 370 xSeries, Installation Manual

Page: 34 / 92

5. If you are not installing an optional memory board, continue with step 6 on
page 22.
If you are installing an optional memory board, touch the static-protective
package containing the memory board to any unpainted metal surface on the
server. Then, remove the memory board from the package. Continue with
step 7.
6. Remove the memory board from the server:
a. Pull both latches
1
simultaneously so that they fully extend from the
memory board.
b. Grasp the two latches and pull the memory board from the server.
c. Place the memory board connector-side up on a flat, static-protective
surface.
7. Touch the static-protective package containing the DIMM to any unpainted
metal surface on the server. Then, remove the DIMM from the package.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, handle the clips gently.
8. Install the DIMM:
1
Latches
2
Retaining clips
3
DIMM
Note: Install the DIMMs in the order indicated on the system label on the
server cover (see note 3 on page 19).
a. Turn the DIMM
3
so that the keys align correctly with the connector.
b. Align the keyed DIMM
3
, and press on both sides of the DIMM as you
insert it into the connector. Be sure to press the DIMM straight into the
connector.
Note: If a gap exists between the DIMM and the retaining clips, the DIMM
has not been properly installed. Open the retaining clips and
remove the DIMM; then, reinsert the DIMM.
22
xSeries 370 Installation Guide