IBM Enterprise Server H80 Series, User Manual

Page: 140 / 190

YES Go to “Running the Diagnostics from a TTY Terminal” on page 75 and
make sure your terminal attributes are set to work with the diagnostic
programs.
Return to “Step 16” when you finish checking the attributes. Record
any settings that were changed.
Step 16
This step loads the Standalone Diagnostics. If you are unable to load the diagnostics,
go to “Step 7” on page 121.
1. Turn on the power.
2. Insert the diagnostic CD into the CD-ROM drive.
3. When the keyboard indicator displays, press the numeric 5 key on the keyboard to
indicate that diagnostics are to be loaded.
4. Enter requested passwords.
5. Follow the instructions to select a console.
Did the Diagnostics Operating Instructions display without any obvious display
problem?
NO Go to “Step 7” on page 121.
YES Go to “Step 9” on page 121.
Step 17
The diagnostics did not detect a hardware problem. If you still have a problem, contact
your software support center.
Problem Determination When Unable to Load Diagnostics
Use the following procedure to obtain an error code. The service organization uses the
error code to determine which field replaceable units (FRUs) are needed to restore the
system to correct operation.
Step 1. Considerations before Running This Procedure
The diagnostics can use a display connected to the video port or an ASCII terminal
attached to a serial port.
Go to “Step 2”.
Step 2
Are the Online Diagnostics installed on this system?
NO Go to “Step 4” on page 125.
YES Go to “Step 3” on page 125.
124
User’s Guide