IBM Enterprise Server H80 Series, User Manual

Page: 139 / 190

NO If Problem Determination was selected from the Diagnostic Mode
Selection menu, and if a recent error has been logged in the error log,
the diagnostics automatically begin testing the resource.
Follow the displayed instructions.
v
If the No Trouble Found screen is displayed, press Enter.
v
If another resource is tested, repeat this step.
v
If the Diagnostic Selection menu is displayed, go to Step 13.
If an SRN is displayed, record it, and go to “Step 14”.
YES Go to “Step 13”.
Step 13
The All Resources option checks most of the configured adapters and devices.
Select and run the diagnostic tests on the resources you are having problems with or
select the All Resources option to check all of the configured resources. Find the
response in the following table and perform the Action listed in the Action column.
Diagnostic Response Action
An SRN is displayed. Go to “Step 14”.
The system hangs. Report SRN 109-200.
The Testing Complete menu and the
No
trouble was found
message is displayed, and
you have not tested all of the resources.
Press Enter and continue with the testing.
The Testing Complete menu and the
No
trouble
was found message displayed and you
have tested all of the resources.
Go to “Step 17” on page 124.
Step 14
The diagnostics produced a SRN for this problem. Do the following:
1. Record the SRN.
2. Report the SRN to the service organization.
3. STOP. You have completed these procedures.
Step 15
When you are loading the Standalone Diagnostics, the attributes for the terminal must
be set to match the defaults of the diagnostic programs. The ASCII terminal must be
attached to Serial Port 1 on the system unit.
Are you going to load Standalone Diagnostics and run them from a ASCII
terminal?
NO Go to “Step 16” on page 124.
Chapter 8. Hardware Problem Determination
123