IBM Enterprise Server H80 Series, User Manual

Page: 136 / 190

Do you want to run the Online Diagnostics in Service mode?
NO Go to “Step 5”.
YES Do the following to shut down your system:
1. At the system prompt, stop the operating system using the
appropriate command for your operating system.
2. After the operating system is stopped, turn off the system unit.
3. Go to “Step 6”.
Step 5
This step starts the Online Diagnostics in concurrent mode.
1. Log on as root or as superuser.
2. Enter the diag command.
3. Wait until the Diagnostic Operating Instructions are displayed, or wait for three
minutes.
Are the Diagnostic Operating Instructions displayed without any obvious console
display problems?
NO Do the following steps to shut down the system:
1. At the system prompt, stop the operating system using the
appropriate command for your operating system.
2. After the operating system is stopped, turn off the system unit.
3. Go to “Step 6”.
YES Go to “Step 9” on page 121.
Step 6
This step loads Online Diagnostics in service mode. If you are unable to load the
diagnostics, go to “Step 7” on page 121.
1. Turn on the power.
2. When the keyboard indicator appears, press the numeric 6 key on the keyboard to
indicate that diagnostics are to be loaded.
3. Enter requested passwords.
4. Follow instructions to select a console.
Did the Diagnostics Operating Instructions display without any obvious display
problem?
NO Go to “Step 7” on page 121.
YES Go to “Step 9” on page 121.
120
User’s Guide