IBM Dock II, User Manual, Page: 92 / 170

The Dock II termination is controlled by the SCSISelect utility. If you
need to disable host adapter termination, first complete the physical
installation; then run this utility. (See “Configuring the Host
Adapter”)
Terminating SCSI Peripherals
1. Read the manufacturer's documentation to determine how to
enable or disable termination on SCSI peripheral devices.
2. Install or enable terminators on SCSI devices at the ends of the
SCSI bus (cable).
3. Remove or disable terminators on all other devices on the SCSI
bus.
4. Be sure the SCSI cables are connected securely. They may have
been loosened if you changed jumper or switch settings on the
peripherals.
Devices Connected to SCSI Bus Host Adapter Termination
External devices only
(host adapter at end of bus) Enabled
Internal and external devices
(host adapter in middle of bus) Disabled
Configuring the Host Adapter
The Dock II includes the menu-driven SCSISelect utility, which lets
you change settings such as host adapter termination without
opening your PC or setting switches. The SCSISelect utility also
includes disk formatting utilities.
Running the SCSISelect Utility
There are two ways to start the SCSISelect utility:
Press Ctrl+A when prompted at boot time.
At the DOS prompt type
debug
and press Enter.
Then at the Debug prompt (a hyphen), type:
76
IBM ThinkPad Dock II User's Guide
Title: C78JAMST CreationDate: 05/06/94 19:15:58