IBM 9306, Hardware Maintenance Manual

Page: 23 / 244

Removing rear filler panels: Use the following procedure to remove the rear filler
panels from the rack cabinet:
1. Grasp the rear filler panel firmly and slide it slowly toward the front of the rack
cabinet.
2. Lift the filler panel and remove it from the rack cabinet.
3. Repeat this procedure to remove both filler panels.
Installing rear filler panels: Use the following procedure to install the rear filler
panels on the rack cabinet:
1. Align the bottom of the rear filler panel with the tab on the bottom rear of the
rack cabinet.
2. Hold the filler panel fully against the side of the rack cabinet; then, slide the filler
panel toward the rear of the rack cabinet. Ensure that both the top and bottom
tabs are engaged by the filler panel.
3. Repeat this procedure to install both filler panels.
Removing and installing NetBAY42 panels
The primary NetBAY42 Rack cabinet comes with side panels installed. Remove the
side panels from a primary rack cabinet, or the outermost rack cabinets in a suite,
before you install or remove optional devices.
Rear filler panel
Figure 9. Removing the NetBAY25 rear filler panels
Type 9306 Model 250/420/421
13