IBM 9306, Hardware Maintenance Manual

Page: 191 / 244

13. Fold the flat panel monitor down until it rests on the rubber bumpers; then,
gently push back and remove the small cable exit cover
1
on the monitor
stand.
14. Route the space-saver keyboard cable through the hole in the front of the base
and out the opening in the back where you removed the small cover; then,
place the keyboard (with its adjustable feet fully down) inside the keyboard
tray.
Note: You must open the flat panel monitor to its full upright position so that
you can install the keyboard and route its cable.
15. Fold the flat panel monitor down again until it rests on the rubber bumpers;
then, reinstall the small cable exit cover
1
.
16. Slide the keyboard tray into the rack; then, neatly route and secure all cables
in the rack using the provided cable straps.
You can now connect the power cord to the flat panel monitor and connect the
display to a server.
Starting the system
Start the system by:
1. Power-on the selector switch(s).
2. Power-on the monitor.
3. Power-on the servers.
Note: The selector switch must be powered on first, then the servers. This is to
assure that the device drivers for the servers send device settings to the
selector switch.
When the selector switch is powered on, it:
v Identifies the mouse and keyboard and puts them into default status.
v Switches to port 1 by default, and displays the number ’1’ in the status flag field
on the monitor.
Figure 87. Routing the keyboard cable
Installing Optional Devices
181