IBM 9006-12C, Manual

Page: 99 / 126

arcconf getconfig 1
Note the Channel and Device numbers of the desired drive. In this example, the channel number is 0 and
the device number is 11.
Reported Channel,Device(T:L) : 0,11(11:0)
Take the drive off line. Run the following
arcconf setstate
command that uses the Channel and Device
numbers from the
arcconf getconfig
command: This command also activates the Fault LED on the
drive.
arcconf setstate 1 device 0 11 ddd
StorCLI commands
Learn about the StorCLI commands. They are for feature code EKAA using a PCIe adapter.
If the command is not installed, download the utility from http://avagotech.com. You can find the
download by searching that site for
storcli . Get their latest “MegaRAID Storcli” download. To install,
follow their documentation. Unzip the file; then for:
RHEL
1. Navigate to the
linux-ppc
folder then to the
Little Endian
folder.
2. Install the package by running this command, where x.xx-x equals the version of the utility. :
rpm -ivh <StorCLI-x.xx-x.noarch.rpm>
Ubuntu:
1. Navigate to the Ubuntu folder.
2.
Install the debian file by using this command:
dpkg -i storcli_x.xx-x._all.deb
To upgrade the StorCLI RPM, run:
rpm -Uvh <StorCLI-x.xx-x.noarch.rpm>
To show a summary of the drive and controller status:
storcli show
To show a list of all controllers and drives that need attention:
storcli show all
To show information about the drives:
storcli /cx[/eall]/sall show
To locate a physical disk by turning on the identify LED:
storcli /cx[/ex]/sx start locate
To turn off the identify LED:
storcli /cx[/ex]/sx stop locate
To prepare a drive for removal:
storcli /cx[/ex]/sx spindown
To prepare a drive for use:
storcli /cx[/ex]/sx spinup
Common procedures for servicing or installing features in the 9006-12C
83